The resolution is 0.15mm - 0.25mm. Infill isn't needed. Support material and brim only used on the 'Mama Whale Body' file. To remove the brim use a sharp knife and file or sand back the brim to the edge of the 'Mama Whale Body' model. The models are printed with RealFilament & Ultimaker PLA in Grey and Pearl White. The 'Mama Whale Body' has been designed with a click hinge that the 'Mama Whale Mouth' should snap fit into straight from the build plate, if not you can file back the hinge on the mouth a bit to create an easier fit.
執照:
公有领域。 免費供個人和商業使用。 無需註明出處。 更多信息。
84下載
Format
STL
Size
149.03cm x 149.03cm x 116.36cm
3D Print Ready
Yes
