The resolution is 0.15mm - 0.25mm. Infill isn't needed. Support material and brim only used on the 'Mama Whale Body' file. To remove the brim use a sharp knife and file or sand back the brim to the edge of the 'Mama Whale Body' model. The models are printed with RealFilament & Ultimaker PLA in Grey and Pearl White. The 'Mama Whale Body' has been designed with a click hinge that the 'Mama Whale Mouth' should snap fit into straight from the build plate, if not you can file back the hinge on the mouth a bit to create an easier fit.
특허:
퍼블릭 도메인. 개인 및 상업용으로 무료입니다. 귀속이 필요하지 않습니다. 더 많은 정보.
84 다운로드
Format
STL
Size
149.03cm x 149.03cm x 116.36cm
3D Print Ready
Yes
