Referência:
3D Print Project Athens on Myminifactory
The resolution is 0.15mm - 0.25mm. Infill isn't needed. Support material and brim only used on the 'Mama Whale Body' file. To remove the brim use a sharp knife and file or sand back the brim to the edge of the 'Mama Whale Body' model. The models are printed with RealFilament & Ultimaker PLA in Grey and Pearl White. The 'Mama Whale Body' has been designed with a click hinge that the 'Mama Whale Mouth' should snap fit into straight from the build plate, if not you can file back the hinge on the mouth a bit to create an easier fit.
Licença:
Domínio Público. Livre para uso pessoal e comercial. Nenhuma atribuição necessária. Mais informações.
84 downloads
Format
STL
Size
149.03cm x 149.03cm x 116.36cm
3D Print Ready
Yes
