Attribution link:
Stuart Ferguson on Myminifactory
Print both parts. Glue a 1/4" dowel or rod into the top part of the mount and slip it through the hole in the bottom part. Make the dowel long enough to fit your largest device with some room to spare so you don't get stuck. Add some weights to the bottom of the dowel (I used two large washers held on with wire, but anything could work). Secure the bottom to a wall or post using #6 wood screws. I also added rubberized tape to the grove in the bottom part to prevent slippage.
License:
MyMiniFactory License. You can use this 3D model for your own commercial purposes. Please credit the designer when sharing this model.
18 downloads
Format
STL
Size
31.6mm x 31.6mm x 45.4mm
3D Print Ready
Yes
