Travel Container 3D-модель

Printed at .1mm layer height at 220C, 30mm/second. No supports needed*. The threading is a little treacherous, so you'll want to take it slow as you build. I printed with Polymaker Polywood for the base, which I'm still trying to properly tune, and which is pretty flimsy. So I lost a little fidelity on the threads, and there was some sagging on the overhangs underneath the lip. Still opens and shuts cleanly and easily, however. * I was concerned about the weakness of the Polywood, so I added an indent to the bottom of the container so I could easily remove it from my print bed without breaking it. That indent does require supports, but I've provided a second stl without the indent that doesn't.

Ліцензія: