Attribution link:
Gabriela Alejandra Bravo Illanes on Myminifactory
The resolution for all parts except the ball is 0.3mm. The ball should be very smooth, so it is recommended to print it with 0.1mm resolution and sand it after print. infil 15% Post-printing Take off the circuit of an optic mouse. 2. Weld wires to each pin of the switch of the right and left button. 3. Weld a flat switch at the end of the wires (One for each button). 4. Put the circuit inside the "Box Mouse", you can fix it with silicone or melt some PLA like in the picture. 5. Fix the "Box Mouse" to the "Box Big". 6. Fix the "Switch Base" on the "Box Big" and fix the flat switch to them. 7. Put over the flat switch the printed Switch, and fix the "Ball Base" where is indicated in the picture. 8. Place the Ball over. 9 Fix the "Box Top". 10. Optionally you can stick something anti-slip at the bottom
License:
MyMiniFactory License. You can use this 3D model for your own commercial purposes. Please credit the designer when sharing this model.
31 downloads
Format
STL
3D Print Ready
Yes
