Attribution link:
Stuart Ferguson on Myminifactory
Print one cap, then print either the unified body or the four quadrants with mirroring. Glue them all together, patch cracks, sand, paint. Finally install round magnets 1/4" across and 1/16" thick into the provided holes on both the base and the disc. Make sure the polarities are correct to snap the units together. Super-glue works very well to hold the magnets in place.
License:
MyMiniFactory License. You can use this 3D model for your own commercial purposes. Please credit the designer when sharing this model.
20 downloads
Format
STL
Size
102.98mm x 102.98mm x 4.7mm
3D Print Ready
Yes
