Assembly Underneath the floor tile, there is a divot for holding the hinge. Straighten and cut a paperclip to fit that divot and then slide it into the hole on the side of the trapdoor. Depending on how well your printer does with bridging, you may need to use an xacto to clean up the divot and a drill or pin vice to clean out the hole in the trap door. Place the trapdoor in place in the floor tile, with the hinge running through it. Place any magnets you want to use in the base. Use cyanoacrylate glue (superglue) to glue the floor to the base, trapping the hinge. Note: the metal hinge will draw the magnets, so you want to slap the floor onto the base pretty fast or it can create a little bit of a mess.
특허:
MyMiniFactory License. You can use this 3D model for your own commercial purposes. Please credit the designer when sharing this model.
51 다운로드
Format
STL
Size
25.31mm x 25.31mm x 25.1mm
3D Print Ready
Yes
