Directions: Print one Quick Release Lever. Clean and open the Lever pivot hole if required to fit onto your tubing. You want a slip fit. Not too tight - Not too loose. Use a small amount of non-petroleum lubricant (for ABS) between the Lever and tubing. Any lubricant should work for PLA or Nylon. Slip Lever onto the tubing between the two bolt holes. Reinstall the tubing, bolts and your New Quick Release Lever. Leave bolts loose. Put Lever into closed position - See Pictures. Tighten/Adjust Bolt tension on the filament. Check Lever operation by Opening and Closing. Open & Close, as required, when required. :-) Springs? A suggestion to those using springs - Use a wood dowel or similar for a pivot rod. The pivot hole diameter of the Lever is approximately 13mm/.512". You will need bolts approximately 50mm/2" in length. These submissions were inspiration used as design aides.: Quick Release Lever for 4mm bolt by jag (http://www.thingiverse.com/thing:7449) Quick Release Lever for 4mm bolt w/Supports by Crypto (http://www.thingiverse.com/thing:13370) Quick Release Lever for wade by Simon Litwan (http://www.thingiverse.com/thing:22830)
특허:
MyMiniFactory License. You can use this 3D model for your own commercial purposes. Please credit the designer when sharing this model.
16 다운로드
Format
STL
3D Print Ready
Yes
