Candy Dish 3D-model

.2mm layer height 50mm/s 20% infill I printed the first ten layers of the model in Polymaker Polyflex at 230 degrees, then printed the remainder in black Hatchbox PLA. I started at 220 degrees to help with adhesion to the Polyflex, then cooled it down to about 200. In order to reduce the dependency on supports, I printed outside-in, which resulted in some obvious blemishes, but nothing that a light sanding couldn't fix.
Licens:
Public Domain. Gratis til personlig og kommerciel brug. Ingen tilskrivning krævet. Mere info.
103 downloads
Format
STL
3D Print Ready
Yes